Safety Tips For Gas Welding

Storage and Handling

  • After finishing gas welding, Always keep gas and oxygen cylinders with minimum of 20 feet distance between them. Or, divide them with a right firewall.
  • As the cylinders can caught fire easily, keep the flammable and combustible materials away from cylinders.
  • Store cylinders away from physical injure, heat, and tampering.
  • Always maintain cylinders in an upright position. If possible, Chain them steadily to keep them from falling over.
  • Ensure that the cylinder valves has been closed or not before moving.
  • Defending caps or regulators should be kept in place.
  • Roll cylinders on bottom edges to move it from one place to another place. Do not pull it.
  • Try to reduce cylinder movement as much as possible, while transporting it.

General Gas Welding Safety Tips

  • To lift up gas cylinders, use the equipments that are designed for lifting it. Do not use any other tools for lifting it.
  • Check torches and clean only with the suitable tools.
  • Blow-back protection torches must be used while welding.
  • Always keep an eye on the equipments and ensure any leakages at all connections. This can be done by using an approved leak-test solution.
  • Inspect hoses for leaks and worn places.
  • Replace bad hoses at regular intervals.
  • Keep fire extinguishers easily reachable places, at the welding site.
  • Keep away hoses and cylinders from sparks, flames, and hot metal as the sparks create holes on it.
  • To fire the flame in welder, always use a flint lighter.
  • Stand to the side when opening cylinder valves.
  • Use two-stage regulators whenever feasible.
  • When using a single-stage regulator, open cylinder valves very slowly. This keeps rapid high pressures from exploding the regulators.
  • When using a single-stage regulator, only open the acetylene cylinder valve 1/4 to 3/4 turn.
  • Leave the wrench in place. By doing so, you can close the cylinder quickly in case of any emergency.
  • Open and light acetylene first. Then open and adjust oxygen to a neutral flame.
  • When shutting off the torch, first you have to close the acetylene torch valve You might hear a pop as the oxygen blows out the flame, but the flame will not burn up the acetylene line.

When you are done:

  • Close cylinder valves.
  • Bleed the lines to take pressure off regulators.
  • Carefully coil hoses.
  • Restore equipment.



Source by Alex David

Leave a Reply

Your email address will not be published. Required fields are marked *